#Tub spout height code#

If you place it in the right place, it would be very easy for the bather sitting inside the tub and the person using the shower to access the faucets controls.ĭetermining the Perfect Location for Your Tub Spout/FillerĪfter determining the standard tub spout height, the next thing you need to determine is the location of the tub filler.

If the tub filler is combined with a shower or if the faucet control is separated from the filler, you should place the faucet handle somewhere between 12-18 inches above the edge of your tub.

Accidental backflow occurs when water is forced to go back into the tub filler or spout.You must avoid accidental backflow because the water source can become contaminated if contaminated water flows back into the filler. Numerous style options are available, so it's easy to match a Roman faucet to the general decor of the bathroom. The angle varies some look like tall kitchen faucet spouts, while others angle outward in a sleek 'L' shape for a modern, minimal look. To prevent accidental backflow, you need to leave enough gaps. The spout on a Roman tub faucet typically arches out over the tub.

If the faucet and the tub filler are attached, you should place them about 2 inches above the rim of your tub.

Finally, you need to know if the spout will be used for baths only or baths and showers before choosing the standard tub spout height.Ĭhoosing the Standard Height for the Tub Filler.

A backsplash will be created if it is placed by the side. Bathtub spouts often have a bigger diameter with a male M28x1 thread.

Ensure that the showerhead, valve, and spout are positioned in the center. Also, bear in mind that the reach can be extended by choosing a pull-out kitchen.The splash can get worse if the water is flowing at a very high rate. Tub filler shouldn’t be placed too high above the tub because the water will splash violently when it hits the bathtub.

Otherwise, the spout will become obstructive and also poke you in your back.

On the other side, the tub filler must not protrude too far.

If the tub filler or spout is too close to your bathroom wall or too short, water will splash down the edge and sides of the tub and fill up your bathroom floor.

The spout must not be closer to the wall or too short.

Some of the things that you need to put into consideration when you want to determine the standard height for a tub spout are:

#Tub spout height code#

In addition, the only actual code requirement is the inclusion of a 2-inch air gap between the bathtub down spout and the top of the tub rim.Factors to Consider When Determining the Standard Height of a Tub Spout If you also have a bathtub, the valve should be installed 8 to 18 inches above the tub. Raymond VinZant, of Bob says that he sets the faucet handle height partially based on the actual size of the family, so that it may be comfortably reached by everyone. A shower valve and spout should be about 38 to 45 inches above ground. If a separate handle assembly controls a combined shower/tub unit as well, then the height of the plumb-in is raised 18 inches above the bathtub spigot plumb-in level by convention. Conventional Standards Are Often UsedĪccording to American Standard US, bathtub spigots and handles are generally plumbed in 4 inches above the top of the bathtub rim. Non ADA compliant installations are a matter regional preference. Handicap accessibility guidelines for buildings and facilities are stipulated under ADAAG requirements says the Access Board, author of much of the ADA language itself. Bathtub Faucet Handle Height Isn't Standardizedīathtub faucet handle height is not specifically regulated by building code, unless the installation intends to meet the Americans With Disability Act of 1990.